Doctor of Philosophy [Ph.D] [Materials Science] From California Institute of Technology

CalTech Ph.D Materials Science is a 4 years Full Time Doctorate program. This program is offered On Campus. The first year fees for Ph.D Materials Science at CalTech is ₹ 56.29 Lakhs (USD 63402). Earlier in 2023, the Ph.D Materials Science Fee was ₹ 50.05 Lakhs (USD 56364). This shows that the academic fees has increased by ₹ 624904 (USD 7038).

CalTech Ph.D Materials Science Total Fees 2025

The tuition fee for Ph.D Materials Science at CalTech is USD 63402 per year (₹ 56.29 Lakhs). Meanwhile, the total cost is USD 65706/Year (₹ 58.34 Lakhs). This includes the tuition fee and other expenses such as Living Cost, Books & Supplies, Health Insurance, etc.

The tuition fee for Ph.D Materials Science at California Institute of Technology is as follows:

The other expenses for Ph.D Materials Science at California Institute of Technology is as follows:

Ph.D Materials Science Tuition Fee Trends at CalTech

CalTech Ph.D Materials Science Fees for Indian students is ₹ 56.29 Lakhs (USD 63402). This academic fee has remained the same from 2023. Candidates can check the year on year trends in CalTech Fees in the table below.

Ph.D Materials Science at CalTech Admission 2025

To be eligible for admission to Ph.D Materials Science at CalTech, applicants must meet specific academic and language requirements.

To be recommended for candidacy for the Ph.D. degree in Materials Science, the student must, in addition to meeting the general Institute requirements, do the following:

a. Courses. To continue in the graduate program, the student must maintain a B– average for each term. Advancement to candidacy requires the successful completion of the program listed under “Core Courses” above. Alternatively, if the student has taken equivalent courses elsewhere, he or she may prove competency to the instructor of the equivalent course at the Institute and request a waiver of the required course. With the above course schedule as a guide, students must complete a minimum of 135 units of courses, numbered 101 or above, plus 2 units of MS 110ab, before presenting themselves for the candidacy exam. The coursework towards the Ph.D. degree in applied physics is typically completed within the first two years of residency at Caltech.

• All units must be taken for grades and passed with a grade of at least a C, except for courses offered only on a pass/fail basis.
• Only courses in which a student has obtained a grade of C or higher will be counted toward the 135 unit minimum.
• No more than 27 units of research through MS 200 can be counted toward the 135 unit requirement of candidacy.
• Students must complete the degree progress report online.
• Alternate Subjects or Areas
  • Students entering the program with advanced preparation may choose either to substitute more advanced courses in the topical areas shown or to demonstrate competency by successfully passing both the midterm and final examinations.
  • Students may petition the option representative to accept alternate subjects or areas.
  • These changes should retain core materials science knowledge, and should represent sufficient breadth.
  • The approval is not automatic; such petitions must be submitted to the option representative and approved before the student registers for the course.

CalTech Ph.D Materials Science Application Link

CalTech Ph.D Materials Science Application Link; Apply Here

Ph.D in Materials Science Fee Comparison

The fee comparison for similar programs like CalTech Ph.D Materials Science are:

• CalTech Courses and Fees 2025
• CalTech Reviews